M365 Scooter Custom Firmware Maker

Choose the base version of your firmware.

if you leave it blank the name will be creation time

Select your wheel size so speeds can be calculated correctly.

Changes the throttle type, power, speed and other parameters.

Lowers the auto braking power on Low mode when the throttle is released. Lowest is smoothest.

Smaller number - less twitching when releasing throttle but delays the max strength.

Change the minimal speed the scooter has to reach to enable auto-braking when the trottle is released.
The scooter will not auto-brake and will (kind off) freeroll bellow this speed.

Enables cruise control to be more or less sensitive to small throttle changes.
Bigger number makes it easier to go into cruise control. (bigger number, more tolerant)

How many seconds it takes for cruise control to kick in.

Changes the beep volume when cruise control enables.

The motor will not start until you push the scooter to this speed.

Select the mode you want the scooter to be when turning on

If checked the modes can be switched while driving.
As you can swith the modes while the throttle is pressed you should be extra careful.

The scooter will stay allways on when its locked, so it can keep the lock on.

Use this if you have custom battery only, as with normal battery this speed is unreachable.

Enable this if you have a custom battery only, and enter the max safe voltage the battery can handle.
Every cell block in series has 4.3V max voltage.
Ex. the factory battery has 10 cell blocks in series, so the max voltage is 4.3 * 10 = 43V .

When you add an external battery, the scooter may go into charging mode when stopped.
This patch fixes that, but disables charging mode when the scooter is on.

Enable this ONLY when you use a custom battery with a compatible open source BMS.
Otherwise leave it disabled.